Chauvet Colordash Manuale Utente Scaricare il pdf (Pagina 13)

Operation

COLORdash™ Accent Series User Manual Rev. 03c -9-

Programming

It is possible to change the fixture’s various operation modes, DMX address, AUTO

programs, or STATIC settings while the fixture is on. Always make sure that you have

clear access to the DIP switches on the back of the fixture for easier fixture changes.

Starting Address

When any of the DMX modes is active as per the Operation Modes Table, you may

select the fixture’s starting DMX address (1~512) by setting DIP switches [1] through [9]

as per the table below.

Starting Address Settings

DIP Switch 1 2 3 4 5 6 7 8 9

Value 1 2 4 8 16 32 64 128 256

Procedure

1) Set DIP switches [10] through [12] to select a DMX operation mode, as per the

Operation Modes Table.

2) Select the desired starting address (0 to 512) by setting DIP switches [1] through [9]

to ON or OFF until the sum of the value of the DIP switches in the ON position

matches the desired address number.

3) Refer to the examples below for more information.

Starting Address

Examples

These three examples are for STAGE 1 DMX mode. Therefore, in all three cases, DIP

switches [10], [11], and [12] are set to OFF.

a) To select DMX Address 1, set DIP switch [1] to ON.

b) To select DMX Address 64, set DIP switch [7] to ON.

c) To select DMX Address 31, set DIP switches [1], [2], [3], [4], and [5] to ON

( 1+ 2 + 4 + 8 + 16 = 31).

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 23 24

Nessun commento

Chauvet Colordash Manuale Utente Pagina 13